Vent mount
This mount has grips that can attach to the bars of a small
vent. The grips slide on tracks which makes it possible for you
to adjust the mount to the positioning of the vents in the car.
Tip! The mount can be placed vertically or diagonally as well
as horizontally, depending on the orientation of the vent bars.
Try it out to find the position that gives the best stability. If you
place the mount vertically or diagonally you can twist the
dock’s position so Car Thing is placed horizontally.
1. Ensure the vent you’ve chosen is in the open position.
Important! If possible you should turn off the vent as
the air flow from the vent can cause noise interference,
making it harder for Car Thing to hear you.
2. Slide and twist the grips to fit your vent.
Note! The gaps between the clamps differs in width,
so you might need to turn them depending on the
thickness of the bars.
3. Push firmly but carefully to place the mount on the
vent.
Important! Go to the Safety information for more information
about how to install the mounts safely.
To Next Page
Loading...
