Dash mount
This mount attaches with adhesive to any vertical surface you
choose.
Important! Before you mount the device, you should carefully
consider the mounting location. The adhesive is very sticky,
can be difficult to move, and is not reusable.
1. Pick an appropriate surface to place the dash mount.
The surface shouldn’t be horizontal as the ball joint
can’t tilt 90 degrees.
Tip! Try out different locations with the protective strip
still attached before deciding on a surface.
2. Use the cleaning cloth to make sure the surface is
clean.
3. Pull off the protective strip from the dash mount.
4. Place the mount on your chosen surface. Press firmly
to make sure the adhesive attaches.
Important! Go to the Safety information for more information
about how to install the mounts safely.
To Next Page
Loading...
