Sprada Filter - SETTING THE AUTO-ON TIME

SPRADA filter manual changes 4/16/07 11:25 AM Page 11
Com
posite
C M Y CM MY CY CMY K
5.3 SETTING THE “AUTO-ON” TIME: (default 11:11 AM)
NOTE: If you push the P-button and do not perform any programming functions, the display will
revert back within a few seconds to the actual time and actual grinder settings.
Display: 3:16 AM/10c MEDIUM.
5.3 a) Push the P-button. The display will show PROGRAMMING GRINDING?>
5.3 b) Rotate the P-button. PROGRAM <TIME ?> will display.
5.3 c) Press the P-button. AUTO ON <TIME ?> will display.
5.3 d) Push the P-button AUTO TIME <AM>
5.3 e) Rotate the P-button to select either AM or PM and push the P-button to confirm.
AUTO TIME <HRS 11> will show on the display.
5.3 f) Rotate the P-button to select the desired hours (example 6).
5.3 g) The display will show AUTO TIME <HRS 6>.
5.3 h) Push the P-button to confirm the hours selection.
5.3 i) Rotate the P-button to select the desired minutes (example 20).
5.3 j) The display will show AUTO TIME <MIN 20>.
5.3 k) Push the P-button to confirm the minutes selection.
• NOTE: You have now set the AUTO-ON time. After a few seconds the display will automatically
return to the actual real-time.
• To check the Auto-Time, push the A-button (M) the button will illuminate green and the display
will show: 6:20 AM / 10 c MEDIUM.
• Push the A-button again, the green illumination will disappear and the display will revert to the actual
real-time and grinder settings. NOTE: “10 c MEDIUM” is the default grinder settings for the
Auto-ON function.
10