Sprada Filter - FILLING THE BEANS; FILLING WATER CONTAINER; FILTER HOLDER INSERT

SPRADA filter manual changes 4/16/07 11:25 AM Page 14
Com
posite
C M Y CM MY CY CMY K
13
7.0 FILLING THE BEANS:
• Fill the Beans Container (Fig. 1, B) with beans. Make sure that the water container lid is closed
to prevent beans from spilling into the water container.
• Caution: Check the beans for foreign objects. The beans container holder approximately 90grams
of beans (good for almost two full pots of coffee). Select the fineness setting (Fig. 3) by turning
the bean container until the line matches up with one of the fours dots in front of the bean
container. For first time use, we recommend the coarsest setting – the largest dot.
NOTE: Never fill the bean container with frozen or coated beans of any sorts.
Damage of the machine resulting for this reason will not be covered by warranty.
8.0 FILLING WATER CONTAINER:
•Open the Water Container Lid (Fig. 1,E) and fill the Water Container with a desired amount of
fresh, cold water. NOTE: Never fill water above the “MAX” line on the water container.
9.0 FILTER HOLDER INSERT:
CAUTION: If the filter holder insert (Fig. 4) is not completely locked into the filter holder, the
drip stop on the bottom of the filter holder insert might not open during brewing. This can cause
hot coffee to overflow and can result in serious injuries and damages. Here is how to properly lock
the filter holder insert into the filter holder:
9.0 a) Open the Water Container Lid
(Fig. 1, E).
9.0 b) Remove the cover lid
(Fig. 5).
9.0 c) Remove the Stainless steel carafe (N) from the pedestal and then lower the filter holder
insert with tab of the filter holder insert pointing towards the water container. Push the handle of
the filter holder insert down towards the water container and make sure it sits completely flush with
the rim of the filter holder
(Fig. 4).