SPRADA filter manual changes 4/16/07 11:25 AM Page 15
Com
posite
C M Y CM MY CY CMY K
9.0 a) Push with your finger against the drip stop (Fig. 6). If the filter holder insert is in the proper
position, it will stay inside the filter holder and not move upwards.
9.0 b) Insert the Goldtone Filter
(Fig. 1, G).
9.0 c) Place the cover lid on top of the filter holder insert. Make sure is sits flush inside the rim
of the filter holder
(Fig. 5).
CAUTION – MESSY AND DANGEROUS:
If you forget to place the filter holder insert in the filter holder and you slide the filter holder
underneath the grinder, is will start grinding and will spread the ground coffee onto the countertop.
It will then return the filter holder underneath the water container and the brewing process will
start, splashing hot water everywhere. In this case, immediately push the On/Off
button to turn off the machine and wait until the machine stops pumping water!
NOTE: Always move the holder WITH the filter holder insert AND the Goldtone filter (G)
underneath the grinder.
10.0 COVER LID (Fig 5.)
The cover lid minimizes static coffee particles clinging to the outside of the filter holder. We recommend
using this lid when you grind for six or more cups of coffee.
Cleaning: Wipe the lid clean after each use. IMPORTANT: The lid is not Dishwasher safe!
Note: The lid has two parts: a soft, removable collar and a hard disk. If you accidentally remove the
collar, just replace is in its original position (with the high rim pointing upwards).
14
To Next Page
Loading...
