Sprada Filter - Using Filter Paper

SPRADA filter manual changes 4/16/07 11:25 AM Page 17
Com
posite
C M Y CM MY CY CMY K
12.1 USING FILTER PAPER:
NOTE: Use “size 4” filter paper only. Always fold the bottom and side crimps over for a proper
fit
(Fig. 10). Do not use a filter paper inside a Goldtone Filter!
12.1 a) Insert Swing the filter holder to the left until it locks itself underneath the grinder
(Fig. 11).
12.1 b) Place the Stainless steel carafe with the closed lid onto the pedestal
(O).
12.1 c) Push the On/Off button
(Fig. 1, J). The red light turns ON.
The grinder will start grinding and the coffee will fall into the filter. Through the
window in the feeder channel cover (Fig. 1, D) you can actually see how the coffee
moves forward. After the grinding has finished, the filter holder will automatically
swing back and underneath the water container lid and the brewing process will
begin.
FIRST TIME GRINDING: First use of the grinder will yield a bit less ground coffee (which is
used to fill the feeder channel
(D) initially). All further grinding will yield the correct amount of
ground coffee.
CAUTION: As long as the grinder is in operation, do not open the bean container lid and do not
insert your finger or any other foreign object into the grinder.
CAUTION: Do not open the water container lid during the brewing process. Hot water could
spill out, causing serious injuries.
12.1 d) After brewing is complete, the red light in the On/Off button will turn off. For the next
1 to 2 minutes hot coffee will still pass from the filter into the carafe, producing coffee.
12.1 e) To serve coffee, remove the carafe from the pedestal. Turn the lid counter clockwise until
the black dot is over the pouring spout
(Fig. 8). You can now pour coffee. After serving,
make sure to close the lid again to prevent heat from escaping from the carafe.
CAUTION: Before pouring fresh water into the water container again, let the machine cool down
for a few minutes.
16