SPRADA filter manual changes 4/16/07 11:25 AM Page 20
Com
posite
C M Y CM MY CY CMY K
19
Dishwasher safe (upper rack): Goldtone Filter and filter holder insert.
Special cleaning tips:
Cover lid: Wipe the cover lid clean after every use. DO NOT CLEAN IN THE DISHWASHER!
If the soft collar becomes separated from the lid, simply replace it with the high rim pointing
upwards
(Fig 5).
Goldtone Filter: Clean after brewing. Do not let used coffee sit for hours in the filter. Coffee
oils will clog the mesh, causing the coffee to overflow the next time it is used.
Filter Holder insert / Drip stop: Clean the filter holder insert and the drip-stop under running
water. Check that the drip-stop opens and closes completely under running water too.
Bean Container: When the bean container is empty, use a dry cloth to wipe out the coffee
oil deposits left inside the container. Never try to disassemble the bean container.
Burr Grinder / Burrs: It is possible that small coffee particles might get stuck in the burrs
grinder. Once every two months, let the beans container run out of beans. Remove the Stainless
Steel Carafe and make sure the Goldtone filter is in place. Move the filter holder underneath the
grinder. Set the grind fineness to the larges / coarsest grind (the largest dot). Push the On/Off
button. While the machine is grinding, tilt the machine forward and give it a gentle pat on the back
to release coffee grounds. This will loosen any coffee grounds and particles and transport them
into the filter holder. Repeat as necessary.
Cleaning the Feeder Channel: Periodically, check the feeder channel for oil deposits and coffee
buildup. As long as you can see coffee flowing freely through the feeder channel window there is
no need to open the cover.
The feeder channel should be cleaned in any of the following situations:
• Moisture or heavy oil build up has caused the ground coffee to block the feeder channel.
• You do not plan to use the grinder for more than a week.
To Next Page
Loading...
