Sprada Filter - GRINDING AND BREWING COFFEE LATER (AUTO MODE); CLEANING AND MAINTENANCE

SPRADA filter manual changes 4/16/07 11:25 AM Page 19
Com
posite
C M Y CM MY CY CMY K
12.5 GRINDING AND BREWING COFFEE LATER (“AUTO” MODE):
12.5 a) Program the timer and grinder settings (as in 5.4 above).
12.5 b) Fill beans into the bean container and the desired amount of fresh water into the water
container.
12.5 c) Make sure that the filter holder insert, Goldtone Filter (or paper filter) and cover lid are
all in place.
12.5 d) CAUTION: Before you swing the filter holder underneath the grinder, make sure there
are no grounds left over in the filter holder from previous grinding.
12.5 e) Swing the filter holder to the left until it locks itself underneath the grinder
(Fig 11).
12.5 f) Now push the “A” button
(Fig 1, M). The button will illuminate green and the display will
switch from the actual time to the “NOW” grind setting, to the Auto-ON time and the
Auto grind setting. At the programmed time, the green light will turn off, the red light on
the On/Off button will illuminate and the grinding / brewing process will begin.
13.0 CLEANING AND MAINTENANCE:
• Make sure the machine is turned off and has cooled down.
• Never use scouring or abrasive agents.
• Never immerse the machine under water.
• Never clean the machine under running water.
18