13
5. The Settings Menu
Wait until water stops coming out of the spout.
The message “Please Rinse” appears on the Display Screen.
Press the Rotary Control Knob.
The machine rinses and is ready for use.
Note: ALWAYS TAKE THE FILTER OUT before descaling!
The Filter loses its eciency after precossing about 50 litres of water.
Note: Even if the Display Screen does not show the message “Replace
Filter” and even if the machine is only used occasionally, the filter
must be changed every two months.
i
i
Operating the machine without a Filter:
If you wish to operate the machine without the filter, you must set the
filter setting to “Filter inserted? No”. This is important because the machine
needs to be descaled more often if operated without a filter, depending
on water hardness. The machine’s default factory setting is “Filter inserted?
N o”.
Press to confirm “No” and the machine reverts to the “Settings menu”.
Turn the Rotary Control Knob to select “Insert Filter? No”,
Press the Rotary Control Knob to conrm your selection.
The water hardness setting will now appear on the Display Screen.
Please note once again: It is possible that the machine’s pipe system
will still be empty when it is set up. This will be indicated when the
machine is turned on using the On/Off Button, as the message, “Fill up
pipe system”, will appear on the display screen.
Place a receptacle with at least 0.5l capacity with its centre under the
spout.
Press the Rotary Control Knob.
The system will now be filled. Water may come out of the spout. After
the system has heated up, the message, “Please rinse” will appear on the
display screen.
Press the Rotary Control Knob.
The system will now be filled with water.
i
To Next Page
