Sprada FUTURE One Touch Cappuccino - Descaling the System

22
7. Care
When the machine needs to be descaled, the following message will
appear on the Display Screen, “Please Descale”. You can also start the
descaling program manually at any time.
Caution: Please follow the instructions below exactly as given! You can
continue to prepare drinks, but we would advise you to carry out the
descaling program as soon as possible.
Caution: You must not interrupt the descaling program whilst it is
running. Never use vinegar or vinegar-based products for descaling.
Always use the liquid products normally recommended for fully
automatic coffee centres.
7.5 Descaling the system
!
Raise the Height Adjustable Spout to its top position.
 Remove the Drip Tray and the Coee Grounds Container and empty
them both.
 If necessary, ll the Water Reservoir with fresh water and put the Water
Reservoir, Drip Tray and Coee Grounds Container back in the machine.
The machine will now start rinsing twice.
The display will now show the message,“Cleaning Tablet in powder shaft”.
 Open the cover on top of the machine.
 Open the lid of the pre-ground coee chamber.
 Place one Cleaning Tablet (available separately, see Section 9) in the
pre-ground coee chamber and close the lid and cover.
 Place a receptacle with at least 0.5ℓ capacity under the Height
Adjustable Spout.
The Display Screen will now show the message “Start Cleaning”.
 Press the Rotary Control Knob.
The machine will now start the cleaning process, and the Display Screen
will show the message “System Cleans”. The cleaning cycle will start
automatically and last approximately ten minutes.
As soon as the cleaning cycle has finished, the Display Screen will show the
message “Empty Tray”.
 Remove, empty and clean the Drip Tray and the Coee Grounds
Container and put them back in the machine.
 If necessary, rell the Water Reservoir with fresh water.
The machine will now heat up and be ready for use again.
!