When charging the battery installed in the machine, the alternator may apply abnormal voltage,
causing damage. Disconnect the battery terminal wire before charging the battery.
Remove all fluid plugs to release the gas generated. Stop charging when the battery is overheated
(liquid temperature exceeds 45 °C).
Stop charging immediately after charging. If you continue to charge, it will appear:
(1) The battery is overheated
(2) Reduce electrolyte levels
(3) Cause battery failure
Do not reverse the connection of [(+) terminal and (-) terminal]. Doing so will damage the
alternator.
Except for battery electrolyte level inspection and specific gravity measurement, please remove the
battery cable when handling the battery.
To Next Page
Loading...