7. Turn the working mode switch up to the outrigger mode
8. Pull back the handles 1 to 4 of the console, the outriggers are
retracted, the two walking tracks are grounded, and the four outriggers
are off the ground.
9. Turn the main key switch from the "start" position to the "stop"
position counterclockwise to turn off the engine.
10. Pull out the outrigger latch, rotate the lever outrigger inward
to retract, and the gas spring will retract accordingly.。
11. When the center of the pole outrigger hole is aligned with the
center of the main outrigger side plate storage hole, insert the
outrigger pin into the storage hole, insert the buckle into the hole at
the other end of the pin, and fix the pole outrigger.
12. Pull out the joint pull pin to a certain height, and rotate the
joint inward. When the joint storage hole is aligned with the storage
hole on the car body, the joint pull pin is automatically inserted into
the hole, and the outriggers are retracted.
13. Follow the same steps to retract the remaining three
outriggers, and the machine boom and outriggers are retracted.
To Next Page
Loading...