Par ts Ma nual 6740 Har vest er
Part #: 290360
Revision: 5/24/2022
x
Product Characteristics
Manufacturer’s address:
Spudnik Equipment Company LLC
584 W 100 N
PO Box 1045
Blackfoot, ID 83221
Phone: (208) 785-0480
Fax: (208) 785-1497
Web: www.spudnik.com
E-mail: spudnik@spudnik.com
Advice concerning inquiries and orders
Please quote the machine serial number when ordering accessories and/or spare parts.
Disposing of replaced parts
The following points should be observed before replacing or disposing of parts.
Replaced parts which still function should be cleaned and stored in an orderly manner.
Machine parts which cannot be repaired should only be disposed of at appropriate collecting points or be collected
by a scrap metal dealer.
So called “valuable” materials should be disposed of in a proper way, i.e. plastics, rubber, scrap metal, etc. should
be recycled.
Collect and dispose of used oil in accordance with local regulations.
The entire designation of the Identification Tag has the
status of a legal document and may not be removed,
changed, or rendered illegible.
IMPORTANT
Identification Tag
The machine Serial Number is stamped
into the Identification Tag located on the
mainframe.
Figure 3
The use of spare parts and/or accessories supplied by third party manufacturers and/or suppliers shall only be permitted
after consultation with a Spudnik representative. Original spare parts and accessories approved by Spudnik are a
contribution to safety and overall performance of the machine. The use of other parts may invalidate the liability of
Spudnik for any consequences arising from such use. Please refer to the ‘Warranty Policy’ and ‘General’ section of this
manual for further clarification.
NOTE
To Next Page
Loading...
