EasyManuals Logo

SPX FIP - series User Manual

SPX FIP - series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
36
A.0100.301 – IM-FIP/08.00 EN (02/2014)
Cause Remedy
Pump is leaking
Pressure too high Decrease pressure by increasing the
diameter of the pipings and also on any filters
installed. Clean filter if installed
Worn shaft seal Replace shaft seal
Worn ball bearings, shaft deflection Replace ball bearings
Common reasons for unnormal wear of the
mechanical seal
• Abrasive liquid
• Liquid is crystallizing
• Sticky liquids
Contact your supplier for further advice.
Insufficient flow
System pressure too high Increase diameter of the pipings, clean filter if
installed.
Pump too small Choose other pump size
Worn pump Replace worn parts
Suction line too small or blocked Increase diameter
Pump speed too low Increase pump speed
Air leakage in suction line Seal the line and the connection ports
Suction hose sucked against tank wall Angle cut the hose
Diameter of suction/discharge line too small
for specified capacity/viscosity
Increase the diameter of the pipings

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SPX FIP - series and is the answer not in the manual?

SPX FIP - series Specifications

General IconGeneral
BrandSPX
ModelFIP - series
CategoryWater Pump
LanguageEnglish

Related product manuals