SPXFLOW C Series - Page 35

Maintenance Waukesha Cherry-Burrell
®
Brand C-Series Pump
01/2019 95-03008-IEC Page 35
15. Remove the seal, cup, and spring from the stub shaft.
16. Remove the key.
17. Remove the seal O-ring from the seal. Discard and replace
the O-ring.
18. Carefully inspect the seal. Replace the seal if it is damaged
or worn.
NOTE: Wh
en the extension end of the carbon seal is less
than 1/32" (0,79 mm) (see Figure 69, item A), replace the
seal.
19. Loosen the drive collar setscrews.
NOTE: Re
moving the drive collar is only necessary if you are
removing the motor or adjusting the seal.
20. Remove the drive collar from the stub shaft.
Figure 66 - Remove seal, cup, and spring
Figure 67 - Remove key
Figure 68 - Remove O-ring
Figure 69 - Carbon Seal
Measurements
A
CT100-029a
Figure 70 - Loosen setscrews
Figure 71 - Remove drive collar