Spypoint FORCE-11 - Settings

10
Use the  and  buttons to navigate in the interface and modify the selection,
the OK button to select and the  button to return to the previous menu.
PHOTO
Allows the user to take photos. When the PHOTO mode is selected,
thetestlightinfrontofthecamerawillashfor60secondsandacountdown
will appear on the screen to allow the user to leave the area without being
photographed.
VIDEO
Allows the user to take videos. When the VIDEO mode is selected,
thetestlightinfrontofthecamerawillashfor60secondsandacountdown
will appear on the screen to allow the user to leave the area without being
recorded.
TEST
Allows the user to test the detection system of the camera. When the
TEST mode is selected, no photo or video is recorded. Walk perpendicularly in
front of the camera. When the camera detects a movement, the busy light and
the test light blink to indicate that normally, a photo or video would have been
recorded. If the system does not detect the movement, increase the detection
distance using the "Sensitivity" option in the settings menu. Realigning the
camera can also be required. In TEST mode, it is possible to take a photo by
pressing the OK button (FORCE-12 only). The photo is saved and appears
in the VIEW mode.
INSTALLATION WITH THE SUPPLIED STRAP
Usethemountingbracketorthecameraslotforinstallationstraptoxthe
camera. The dimensions of the strap (included) is 1" X 60".
Recommended installation height: about 3 feet above the ground.
Do not place the camera facing the sun.
1. Insérez l’extrémité de la courroie dans la fente
qui se trouve au dos du mécanisme.
2. Insérez la courroie dans la fente sous le levier
et faites-la ressortir en arrière.
3. Créer une tension sur la courroie en la tirant vers
la droite, puis rabattez vers la gauche le levier pour
maintenir la position.
Settings
FORCE


