Spypoint LINK-MICRO-LTE - Memory Card Usage; MicroSD Card Installation; MicroSD Card Removal; Continuous Recording Note

LINK-MICRO-LTESPYPOINT
8
INSTALLING A MICROSD CARD (NOT INCLUDED)
The use of a memory card is necessary for the operation of the camera. It is used to save pictures and other
camera status les. Note that photos in their original format are kept on the memory card. The photos sent
to your application are lighter versions. You can retrieve your photos at any time by removing the card from
the device and transferring the contents to another device (e.g.: computer).
Your camera requires a memory card type microSD, with a maximum capacity of 32 GB, sold separately.
Here is a table showing the approximate quantity of photos that can be recorded on the card, according to
dierent memory card capacities.
INSERTING YOUR MICROSD CARD
Before inserting the microSD card into your camera, it must be formatted via a computer to ensure
proper operations. Visit www.spypoint/support if you need help formatting your microSD card.
• Ensure the camera is turned OFF.
• Find the microSD card slot. It is located on the left,
above the battery compartment (see photo).
• Insert a microSD card (up to 32GB) in the microSD
card slot with the metal contacts facing down.
• The card is inserted correctly when a click is heard.
REMOVING YOUR MICROSD CARD
• Before removing a memory card, always turn your camera OFF
to prevent les from on the card from being deleted or damaged.
• To remove the card, push it lightly into the camera until you hear a click.
Then take it out of the device.
MEMORY
4 GB 8 GB 16 GB 32 GB
PHOTOS 10 MPX
1,900 3,800 7,600 15,200
NOTE
The LINK-MICRO-LTE is equipped with continuous
le recording. This means that when the memory
card is full, the camera continues to save your
pictures by erasing the rst recorded les.
Memory Card