37Brake Hose Installation
Install the compression fitting and nut into the lever.
Use a flare nut crowfoot with a torque wrench to tighten the
compression nut to 8 Nm (71 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a shop
towel.
⚠ CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
5
8 mm flare nut crow foot 8 Nm (71 in-lb) 22 mm
6
To Next Page
Loading...
