7Troubleshooting
Troubleshooting
NOTICE
Do not apply DOT brake fluid or grease to caliper pistons when performing troubleshooting procedures. Use of DOT brake fluid or grease can
diminish braking performance and cause rotor rubbing.
If your brakes exhibit excessive lever throw or spongy feel, perform the following steps before bleeding the system:
Clamp the bicycle into a bicycle work stand.
Remove the wheel from the aected caliper.
Remove the E-clip from the pad retention bolt.
Remove the pad retention bolt from the caliper.
Remove the brake pads and pad h-spring from the caliper.
Insert two brake rotors into the caliper rotor slot.
1
Needle nose pliers 20 mm or 15 mm Thru Axle
2
3
4
To Next Page
Loading...
