39G2 Ultimate Lever Bearing Replacement
G2 Ultimate Lever Bearing Replacement
This service requires the Lever Pivot Bearing Press Tool
Install the threaded bearing press into the lever body with the recessed
face of the press facing the bearing to be removed.
Install the bearing press onto the bearing press bolt and thread into the
threaded bearing press.
Tighten the bearing press bolt until the bearing is pressed through the
lever body and into the threaded bearing press tool recess.
Unthread the bearing press bolt to remove the tools and old bearing.
Discard the bearing.
Repeat steps 1-3 to remove the other bearing.
Clean the lever body bearing bores.
1
2
3
2.5 20 mm or 15 mm Thru Axle
4
To Next Page
Loading...
