SRAM HydroR - Sram Hydraulic Hose Replacement; Parts, Tools, and Supplies

26
SRAM® Hydraulic Hose Replacement
Tighten the brake lever onto the handlebar in the previous recorded
position. Return the reach adjust to its original position. Route the
hose through or onto the frame according to the frame manufacturer's
instructions. Install the shifter cable to the derailleur according to the
user manual at www.sram.com/service.
⚠ CAUTION
Servicing your shift-brake or brake lever removes fluid from the system, you must bleed the brakes. For brake bleed and brake pad replacement
instructions, consult the HydroR™ Hose Shortening and Bleed Manual at www.sram.com/service.
SRAM® Hydraulic Hose Replacement
Perform the hose replacement service if the hose needs to be replaced. For hose shortening instructions, consult the HydroR™ Hose Shortening and
Bleed Manual at www.sram.com/service.
Parts, Tools, and Supplies
Parts
• SRAM road disc brake hydraulic hose kit
Safety and Protection Supplies
• Apron
• Clean, lint-free rags
• Nitrile gloves
• Oil pan
• Safety glasses
Lubricants and Fluids
• Isopropyl alcohol
• SRAM DOT assembly grease
SRAM Tools
• Bleed block hydraulic road disc
• SRAM hydraulic hose cutter tool
Bicycle Tools
• Bicycle work stand
Common Tools
• Crowfoot wrench: 8 mm, 9 mm
• Digital caliper
• Flare nut wrench: 8 mm
• Hex wrenches: 2.5 mm, 4 mm, 5 mm
• Hex bit sockets: 2.5 mm, 4 mm, 5 mm
• Marker
• Needle nose pliers
• Open end wrench: 6 mm, 10 mm
• Phillips #1 screwdriver
• Pick
• Torque wrench
• TORX® wrenches: T8, T10, T25
• TORX bit socket: T10, T25
11
5 mm 6-8 N·m (52-70 in-lb)