SRAM HydroR - Caliper Brake Pad Removal

9
Caliper Brake Pad Removal
Caliper Brake Pad Removal
Remove the caliper mounting hardware from the caliper, then set them
aside in the order that they were removed.
Flat mount: Leave the mounting bracket installed.
Remove the E-clip from the pad retention bolt.
Remove the pad retention bolt from the caliper.
Remove the brake pads.
NOTICE
Brake pads must be replaced if the total thickness of the backing plate
and pad friction material is less than 3 mm.
1
2
Needle nose pliers
2.5 mm
3
Digital caliper