31
Hose Installation
Remove the four reservoir cover bolts.
Use a rag to remove the reservoir cover and bladder assembly. Discard
the fluid into an oil pan.
Remove the banjo bolt and discard the hose.
Hose Installation
Spray isopropyl alcohol on the reservoir, bladder, and reservoir cover
and clean them with a rag. Install the bladder onto the reservoir cover.
NOTICE
If the brake system has been contaminated with mineral oil or DOT 5
fluid, flush all of the parts with soapy water, rinse them with clean water,
then allow all the parts to dry prior to rebuilding. Install new seals, a
new bladder, and replace the hose.
10
To Next Page
Loading...
