SR715/720 LCR METER
x
Typical measurement setups
The table below lists suggested test conditions for various types of components. This is by no means the only
set of conditions for measuring, but is a good general "rule of thumb".
Setups for Measuring Typical Parts
Component
Type
Value
Parameter
Type
Equivalent
Circuit
Frequency
Unknown: Any Auto series 1 kHz
Resistors:
< 1 kΩ
R+Q series 1 kHz
> 1 kΩ
R+Q series 100 or 120 Hz
< 10 µH
L+Q series 100 kHz
10 µH – 1 mH
L+Q series 10 kHz
1 mH – 1 H L+Q series 1 kHz
> 1 H L+Q series 100 or 120 Hz
<10 pF C+D parallel 10 kHz
10 pF – 400 pF C+D series or parallel 10 kHz
400 pF – 1 µF
C+D series 1 kHz
> 1 µF
C+R or C+D series 100 or 120 Hz
To Next Page
Loading...
Need help?
General