ST ST-LINK/V2 - Low-Cost SWIM Connection; SWIM Signals and Connections; Figure 6. Key Details on Connectors; Figure 7. Low-Cost Connection

Hardware configuration UM1075
10/20 UM1075 Rev 10
Figure 6. Key details on connectors
4.1.2 Low-cost SWIM connection
Figure 7 shows how to connect the ST-LINK/V2 if a 4-pin, 2.54 mm, low-cost SWIM
connector is present on the application board.
Figure 7. Low-cost connection
1. A = Target application board with 4-pin, 2.54 mm, low-cost connector
2. B = Wire cable with a 4-pin connector or separate-wire cable
3. C = STM8 SWIM target connector
4. See Figure 12
4.1.3 SWIM signals and connections
Table 2 summarizes the signal names, functions, and target connection signals when using
the wire cable with a 4-pin connector.
A
B
C
A
B
C