14
en
The REF button can be used to select any set angle as 0°
reference. The angle details now displayed relate to this
reference angle.
The display flashes in this setting.
A
The original reference angle value is displayed
for 2 seconds by briefly pressing the REF button.
B
The reference angle is deleted by:
• Pressing and holding (≥ 3 sec) the REF button
If the keylock is active, this must be disabled first.
• Switching off
• The automatic switch-off function
The zero position again refers to the calibrated setting.
The chosen orientation of the electronic spirit level must
not be changed while using the reference function!
5.6 Freely selectable zero position REF
+5°
(= 25° )
0°
(= 20° )
20°
( + 5° )
RESET
REFERENCE
REFERENCE
20°
3 sec
3 sec
2 sec
A
B
To Next Page
Loading...
