Stack-On QAS-1514-B - Safe Operation and System Management; Opening the Safe Using Fingerprint; Clearing Memory; Removing Safe from Mounting Bracket

REMOVING THE SAFE FROM THE
MOUNTING BRACKET
40667-1512
4
15
Mounting
Bracket
Thumb nuts
OPENING THE SAFE USING YOUR
FINGERPRINT
To open the safe, press the scanner with a recorded
nger. e blue light will come on with one beep
(if the sound is turned on) and the scan will begin.
If the green light ashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted
and the door will open.
If the red light ashes once, the scanner did not
read your ngerprint and you must try again. If the
red light ashes 3 times, the scanner read your
ngerprint and did not accept it.
If there are 3 rejected scans, where your
ngerprint was read, and the red light ashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again. e safe
will beep one time (if the sound is turned on)
and the green light will ash once when the
lockout period is over.
If there is 1 more rejected scan where your
ngerprint was read and the red light ashes 5 times
with 5 beeps (if the sound is turned on), you will
have an automatic lockout for 5 minutes before you
can try a scan again. e safe will beep one time (if
the sound is turned on) and the green light will ash
once when the lockout period is over.
To close the safe, push the door closed until
locked.
TURNING THE SOUND OFF/ON
CLEARING THE MEMORY
To turn the sound o, press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.
Your safe comes with the beep sound turned on.
To clear the memory of all recorded ngerprints,
locate the reset buon on the inside of the safe
and press this buon for about 5 seconds until
the green light ashes 10 times with 10 beeps (if
the sound is turned on). All recorded scans will
be erased.
NOTE: For security you must record a
ngerprint. Failure to do so will compromise
the safety and security of the safe.
Open the holster compartment as described in the
Installing the Baery section. When the holster
compartment has been released from the frame and
the L brackets have been rotated so they are at
against the back of the holster compartment, locate
2 nuts which are located in the boom of the safe
body. Remove the 2 nuts and washers using your
ngers and li the safe o the tabs in the back of the
sleeve.
ere are some securing tabs on the mounting
sleeve that guide the back of the safe into position -
you will need to make sure you have maneuvered the
safe out of these tabs.