Stack-On QAS-1514-B - Installation, Mounting, and Maintenance; Selecting a Mounting Location; Securing the Safe; Scanner Maintenance

STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
e safe must be secured to the mounting bracket.
e safe installed in the mounting bracket must be
mounted to a wall or solid surface.
For optimal
safety and security, the safe should be installed in
an isolated, dry and secure area.
SECURING THE SAFE
SELECTING A LOCATION
NOTE: is safe must always be secured in the
mounting bracket and mounted to a wall or
solid surface. Failure to do so will compromise
the safety and security of the safe.
Secure the mounting bracket to wall studs using
the pre-drilled mounting holes in the bracket and
hardware provided.
NOTE ON LOCKING THE SAFE: e safe
needs to be in an upright position, as shown in
gure 3, for the locking mechanism to
function properly. Failure to mount the safe
in the correct upright position will
compromise the safety and security of the
safe.
NOTE: e mounting bracket must be
secured to a wall stud on one side of the
bracket in the top and boom holes so that it
is anchored to the wall stud in two locations.
Wall anchors should be used on the other side.
e bracket should be secured in 4 locations.
Use the hardware provided or consult your
hardware retailer for fastening hardware for
your particular mounting surfaces. Aer the
mounting bracket is secured you must secure
the safe to the bracket to insure the optimal
safety and security of the safe.
Place the mounting bracket in the desired
location and mark the mounting holes to be
used with a pencil. Move the mounting bracket
and drill the pilot holes for the screws. For
mounting to a wall stud, drill a 3/16” diameter
pilot hole and aach the bracket using the Lag
screws and washers.
Place the safe back into the mounting bracket
and replace the 2 thumb nuts and washers.
Secure the holster compartment in place,
following the steps in Closing e Safe section
of these instructions. Close and lock the safe
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
40667-1512
5
15
Lag screws
Mounting
Bracket
IMPORTANT
Keep your keys in a secure place, away from
children. Keep this record of your serial number in a
secure place separate from your safe. To order a
replacement key set, follow the instructions on the
aached form.
e biometric scanner may be cleaned with
household glass cleaner and a coon cloth.
MAINTENANCE