1. Insert the suspension bolt in the overhead suspension.
Insert the suspension bolt (1) in position (1) with spacer sleeves.
➢ Set the correct dimension through the symmetrical distribution of the distance wash-
ers and spacer sleeves.
Insert the suspension bolt (2) in position (2) without spacer sleeves.
➢ Set the correct dimension through the symmetrical distribution of the distance wash-
ers.
2. Fit the trolley side cheeks on the suspension bolts.
3. Adjust runway width with adjusting washers (see chapter Adjust trolley to runway
width).
➢ Overhead suspension must be central to the trolley.
4. Tighten the nut with the specified torque (470 Nm).
5. Attach screw locks.
To Next Page
Loading...
