Stahl ST10 - Attach the Trolley to the Runway Beam

4 Installation
01.2019 23
ba-o.1.8.0-en-3.1
4.4 Attach the trolley to the runway beam
(1)
Screw lock
(2)
Nut
(5)
Trolley side cheek
a
Track clearance
Fig. 19
1. On one side, loosen the screw lock (1) and nut (2) and open the trolley side cheek (6)
sufficiently far that the trolley fits on the runway beam.
2. Attach the trolley to the runway beam.
3. Make sure that the track clearance (a) is not greater than 3 mm on one side; if
necessary readjust the trolley (see chapter Adjust trolley to runway width).
4. Tighten the nut (2) with the specified torque (see table).
5. Attach screw locks (1).
Type
Nm
US-G10
Tighten castellated nut and then release to the next cotter pin hole.
K.T 22
52
KFN 10
KFK 10
130
KFN 32
KFK 32
470
KFN 63
KFK 63
1100