21
5. Specific Operation Manual
5. Specific Operation Manual
2) You can upload the data of test results to PC through RS232C.
The data form uploaded is the same as paper printing style.
3) Uploading mode is for transferring data of the test results to PC in
a lump.
Data input can be made by pressing numeric keys or direction
keys (◀ / ▶). Press ENT key to operate a system.
4) Printing mode is for printing data of test results in a lump. You
can input data, pressing numeric keys or direction keys (◀ / ▶).
Press ENT key to operate a system. The printer capacity is limited
to 50 test results at one time.
5) You can move to each item by using up/down (▲ / ▼) keys. if
test memory is full (2,000 tests), 2,000 tests previously saved data
is erased on a first in and first out basis. To erase all saved data in
put the number of “9999” and press “ENT” key.
6) If data base is empty, an error message of “No Data in Data Base”
will appear at the center of display and go back to previous mode.
After all data processing is finished completely, a message of
“OK Finish !” will appear on the screen.
To Next Page
Loading...