7
ENGLISH
(Original instructions)
11 . Do not operate or store this product in temperatures below
40°F (4°C). Freeze damage is not covered by thewarranty.
12 . Carefully observe all chemical instructions and
warnings before using. Use only approved pressure
washer cleaners. Do not use bleach, chlorine, or any
cleaners containing acids. Always follow manufacturer’s
label recommendations for proper use of cleaners. Always
protect eyes, skin and respiratory system fromcleaners.
13 . The pressure washer should not be used in areas
where gas vapors may be present. An electric spark could
cause an explosion orfire.
14 . To minimise the amount of water getting into the pressure
washer, the unit should be placed as far as possible from the
cleaning site duringoperation.
15 . To prevent accidental discharge, the spray gun should be
secured by locking the trigger when not inuse.
16 . To allow free air circulation, the pressure washer should NOT
be covered duringoperation.
17 . Never touch, grasp or attempt to cover a pinhole or similar
water leak on the high‑pressure hose. The stream of water IS
under high pressure and WILL penetrateskin.
18 . Use only hoses and accessories rated for pressure higher than
your pressure washer’s PSI / Bar. Never use with any other
manufacturer’s accessories orcomponents.
19 . Never defeat the safety features of thisproduct.
20 . Do not operate machine with missing, broken or
unauthorisedparts.
21 . Never spray flammable liquids or use pressure washer in
areas containing combustible dust, liquid, orvapors.
WARNING: This machine has been designed for use
with the cleaning agent supplied or recommended by
the manufacturer. The use of other cleaning agents
or chemicals may adversely affect the safety of
themachine.
WARNING: During use of high pressure cleaners,
aerosols may be formed. Inhalation of aerosols can be
hazardous tohealth.
WARNING: High pressure jets can be dangerous
if subject to misuse. The jet must not be directed at
persons, live electrical equipment or the machineitself.
WARNING: Do not use the machine within range of
persons unless they wear protectiveclothing.
WARNING: Do not direct the jet against yourself or
others in order to clean clothes orfootwear.
WARNING: Risk of explosion – Do not spray
flammableliquids.
WARNING: High pressure cleaners shall not be used by
children or untrainedpersonnel.
WARNING: High pressure hoses, fittings and couplings
are important for the safety of the machine. Use
only hoses, fittings and couplings recommended by
themanufacturer.
WARNING: To ensure machine safety, use only original
spare parts from the manufacturer or approved by
themanufacturer.
WARNING: Water that has flowed through backflow
preventers is considered to benonpotable.
WARNING: The machine shall be disconnected from
its power source during cleaning or maintenance and
when replacingparts.
WARNING: Do not use the machine if important parts
of the machine are damaged, e.g., safety devices, high
pressure hoses, triggergun.
WARNING: Always switch off the mains disconnecting
switch when leaving the machineunattended.
WARNING: Depending on the application, shielded
nozzles can be used for high pressure cleaning,
which will reduce the emission of hydrous aerosols
dramatically. However, not all applications allow the use
of such a device. If shielded nozzles are not applicable
for the protection against aerosols, a respiratory mask of
class FFP 2or equivalent may be needed, depending on
the cleaningenvironment.
WARNING! High pressure jets can be dangerous if
subject tomisuse.
According to the applicable regulations, the
appliance must never be used on the drinking
water network without a system separator. Use
a separator as per IEC 61770. Water flowing
through a system separator is considered
notdrinkable.
Read all of this manual carefully before operating
theappliance.
• The intended use is described in this manual. The use
of any accessory or attachment or the performance
of any operation with this appliance other than those
recommended in this instruction manual may present a risk
of personalinjury.
• Retain this manual for futurereference.
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN60335-2-79 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment ofexposure.
WARNING: The vibration emission value during actual
use of the pressure washer can differ from the declared
value depending on the ways in which the tool is used.
The vibration level may increase above the levelstated.