42
WARNING! The maintenance task frequency depends on the quality of the pellets.
Note: See the warning label and read the maintenance instructions in chapter 18.
• K1700 and K2300
To carry out this maintenance on the water version salamander, the air passages must be cleaned. To do this, lift the lid on the
upper part of the stove (Figure 36-a) and then turn and lift several times the knobs (Figure 36), in order to remove the dirt
accumulated inside the pipes.
a) b)
Figure 36 - Cleaning the turbulators
The inside of the stove should then be cleaned by scrubbing the surfaces with a steel brush (Figure 37).
Figure 37 - Cleaning the interior
Then remove the burner basket (Figure 38-a) and the ash basket (Figure 38-b) and vacuum the ashes out of both. It is also
necessary to clean the inside of the stove by opening the front trap, as shown in Figure 40. Finally, assemble the parts in the
reverse order in which they were removed and close the door of the appliance.
a) b)
Figure 38 - a) Burning basket; b) Ash basket
To Next Page
Loading...
