Star Micronics NX-1000 series - Introduction; Printer Model and Manual Overview

INTRODUCTION
This manual describes dot matrix printers as shown below.
It is intended for use as a reference for periodic inspections and maintenance procedures.
This manual is prepared for use at a technical level and not for the general user.
Model Interface Mono/Colour Destination Ver.
NX-1000MULTI-FONT PRINTER Parallel Type Monochrome
NX-1000CMULTI-FONT PRINTER Commodore Type Monochrome
NX-1000COLOUR PRINTER Parallel Type Colour
NX-1000C COLOUR PRINTER Commodore Type Colour
LC-10 MULTI-FONT PRINTER Parallel Type Monochrome
LC-10CMULTI-FONT PRINTER Commodore Type Monochrome
LC-10 COLOUR PRINTER Parallel Type Colour
LC-10C COLOUR PRINTER Commodore Type Colour
NX-1000 II MULTI-FONT PRINTER Parallel Type Monochrome
LC-10 II MULTI-FONT PRINTER Parallel Type Monochrome
• This manual is divided into the following sections:
Chapter 1 General Specifications
Chapter 2 Theory of Operation
Chapter 3 Adjustments
Chapter 4 Parts Replacement
Chapter 5 Maintenance and Lubrication
Chapter 6 Troubleshooting
Chapter 7 Parts List (Ver. 1 and Ver. 1.5)
Chapter 8 Parts List (Ver. 2)
Appendix Explanation of Principle ICs
• First edition : Nov. 1987 Only Monochrome Type
Second edition : Mar. 1988 Add Colour Type
Third edition : Dec. 1988 Add Ver. 1.5 of Parallel Type
Fourth edition : Jul. 1989 Add NX-1000 II and LC-10 II (Ver. 2 of Parallel Type)
Fifth edition : Apr. 1991
Sixth edition : Aug. 1993
Seventh edition :Sep. 1995
Eighth edition :Apr. 1996
Ninth edition :Aug. 1997
Except for
European market
For European
Market
For American
and Asian market
For European and
Pacific market
Ver. 1
and
Ver. 1.5
Ver. 2
1
2
3
4
5
6
7
8
APP.