Star Micronics NX-1000 series - Upper Case and Printer Mechanism Replacement

PARTS REPLACEMENT
– 37 –
1. Upper Case Unit
(1) Turn off the power switch [1] .
(2) Remove
• Printer cover
• Rear cover
• Platen knob [2]
• Four screws [3]
(3) Move the Carriage Unit [4] over to the right so that
it aligns with the cut-out of the upper case unit [5] .
(4) Remove
• Upper case unit [5]
Clasp the back side of the upper case unit, and
gently push it further forward.
• Control panel board [6]
2. Printer Mechanism
(1) Remove
• Upper case unit according to the procedure de-
scribed in item 1.
• Stop ring [1]
• Release lever [2]
• Gear lever [3]
• Four tapping screws [4]
• Screw [5]
• Connector cover [6]
Lift up the tab of the connector cover, and slide it
to the right for removal.
• Printer head cable [7]
• Three connectors [8]
• Printer mechanism [9]
Caution in assembly:
Align the the ∆ mark on the Release lever [2] with
the ∆ mark on the Release gear [3] to install the
Release lever [2] .