– 48 –
MAINTENANCE AND LUBRICATION
2. Lubrication
Lubrication is very important to maintain optimum performance and to prevent trouble.
2-1. Lubricant
The type of lubricant greatly affects the performance and durability of the printer, especially in a low temperature
environment. We recommend use of the grease and lubrication oils listed below for this printer
Product name Maker
FLOIL GB-TS-0 and FLOIL GB-100 Kanto Chemicals Co., Ltd.
KF96-1000CS and KF96-SP Shinetsu Chemical Industry
Mobil 1 Mobil oil
2-2. Lubricating Method
When lubrication is carried out in assembly and disassembly, wash parts well to remove dust and dirt before lubrication.
Lubrication must be carried out regularly once every 6 months or after 1 million lines have been printed. Lubrication is
necessary irrespective of the regular lubrication whenever lubricant becomes deficient after cleaning or whenever parts
have been disassembled or replaced.
2-3. Lubricated Areas
NO. Lubrication Product Name
[1] Rubbing surfaces of idler gear 16 × 72 × 0.5 and idler gear shaft GB-TS-0
[2] Rubbing surfaces of gear 40 × 0.5 and gear shaft GB-TS-0
[3] Rubbing surfaces of adjusting lever and frame GB-TS-0
[4] Rubbing surfaces of timing pulley and pulley shaft GB-TS-0
[5] Rubbing surfaces of rear angle and carriage GB-TS-0
[6] Rubbing surfaces of bushing and carriage stay Mobil 1
[7] Rubbing surfaces of timing pulley and stop ring GB-TS-0
[8] Rubbing surfaces of release shaft and frame GB-TS-0
[9] Rubbing surfaces of release lever and tractor shaft GB-TS-0
[10] Rubbing surfaces of two tractor bushings and tractor shaft GB-TS-0
[11] Rubbing surfaces of tractor holder and tractor cover KF96-1000CS
[12] Rubbing surfaces of bail roller and shaft KF96-SP
[13] Rubbing surfaces of timing pulley and pulley bushing GB-100
[14] Rubbing surfaces of lift cam and ribbon change lever GB-TS-0
[15] Rubbing surfaces of lift cam and carriage shaft GB-TS-0
[16] Rubbing surfaces of ribbon change lever and carriage KF96-1000CS
[17] Rubbing surfaces of idler gear 16 × 1 – 40 × 0.3 GB-TS-0
[18] Rubbing surfaces of lift lever assy and carriage shaft KF96-1000CS
[19] Rubbing surfaces of lift lever assy and carriage GB-TS-0
[20] Rubbing surfaces of lift lever assy and lift cam KF96-1000CS
[21] Rubbing surfaces of ribbon cassette gear and carriage shaft GB-TS-0
[22] Rubbing surfaces of rear angle and idler gear 16 × 1 – 40 × 0.3 GB-TS-0
[23] Rubbing surfaces of idler gear 43 × 6.3 × 0.3 and carriage shaft GB-TS-0
[24] Rubbing surfaces of idler 43 × 6.3 × 0.3 and gear cover GB-TS-0
[25] Rubbing surfaces of idler gear 17 × 41 × 0.3 and clutch lever GB-TS-0
[26] Rubbing surfaces of idler gear 16 × 1 – 40 × 0.3 and carriage shaft GB-TS-0
[27] Rubbing surfaces of lift cam and gear cover GB-TS-0
[28] Rubbing surfaces of wave washer and poly-slider GB-TS-0
To Next Page
Loading...
