Star Micronics NX-1020 - Carriage Motor Unit; Print Head

PARTS REPLACEMENT
– 46 –
7. Print Head
(1) Remove
• Printer Cover
• Ink ribbon cartridge
• Color ribbon holder [1]
• Two tapping screws [2]
• Head cable [3]
• Print head [4]
WARNING
The print head gets hot after printing. Do not
touch it until it get cool.
(2) Adjust
• Gap between print head and platen
Refer to item 1 of Chapter 3.
8. Carriage Motor Unit
(1) Remove
• Upper case unit according to the procedure de-
scribed in item 1.
• Connector CN6 [1]
• Three screws [2]
• Spring [3]
• Two screws [4]
• Carriage motor unit [5]
Note:
The color of the connector [1] on the carriage
motor unit [5] has been changed from white to red;
however the motor itself has not been changed.