ā 6 ā
GENERAL SPECIFICATIONS
3. EDS Mode Settings
The EDS (Electronic DIP Switch) mode has 16 kinds of functions you can set as the power-on default. To enter the EDS
mode, turn the printer on while simultaneously holding the , , and buttons.
In EDS mode, the indicators and the buttons on the control panel are used as shown below in Figure 1-4.
EDS Mode
Fig. 1-4 Button and indicator functions in the EDS mode
Number Function ON OFF
A-1 Emulation STANDARD IBM
A-2 RAM Usage Input Buffer Download
A-3 Auto-LF Disabled Enabled
A-4 ASF Setting Disabled Enabled
B-1 Multi-part mode Disabled Enabled
B-2 Paper-out Detector Enabled Disabled
B-3 Tear off Disabled Enabled
B-4 Strobe Timing Normal Reverse
C-1
C-2
C-3
C-4
D-1 Character Table
(Standard mode) Graphics Italics
(IBM mode) Set #2 Set #1
D-2
D-3 (See next page)
D-4
Print Mode (See next page)
Page Length (See next page)
*1
IBM Code page or
International Character Set
*1 See figure 1-5.
ON LINE
PAPER FEED
SET/EJECT
PARK
To Next Page
Loading...
