Star Micronics SM-S230I Series - Page 23

Follow the procedure below to change the printer settings.
2. To put the printer into Memory Switch Setting mode, press and hold both the POWER button and
FEED button. After the ERROR lamp ashes ve (5) times, you can congure the settings. Release the
buttons after you surely conrm the lamp ashes ve (5) times, to get a printer into the setting mode.
CAUTION
Before changing the memory switch settings, make sure that the communication with a host
device is disconnected.
When the printer is under the Bluetooth communication with a host device, it cannot enter the
Memory Switch Setting mode.
1. Press and hold the POWER button for approx. 5 seconds, and printer is turned on.
5 times
FEED button: Changes the printer mode.
POWER lamp: Blinks by the number of cycles corresponding to the mode selected
by the FEED button.
ERROR lamp: Blinks by the number of cycles corresponding to
the setting selected by the power button.
POWER button: Changes the setting.
* The numbers of blinks made by these lamps
are indicated in the relevant columns in
the memory switch setting table.
- 23 -