Simple method of switching over between ESC/POS and StarPRNT emulation modes
1. Turn the printer power and open the printer cover.
2. Press and hold the POWER button and the FEED button simultaneously. As soon as the ERROR lamp
ashes ve times, release the buttons. The emulation switchover takes place automatically.
3. After setting a paper, close the printer cover. The set emulation mode is printed out.
ESC/POS mode: EMU = ESC/POS
Star Line mode: EMU = StarPRNT
If the emulation mode is not switched correctly, repeat the above steps 1 to 3.
At that time, in step 2, make sure not to release the buttons until the lamp completes the 5th ash.
4. Please reboot the printer after switching the emulation between StarPRNT and ESC/POS.
*It will be valid after rebooting the printer.
As soon as,
release the buttons.
5 times
- 27 -
To Next Page
Loading...
