Initialization of memory switch setting (factory setting)
To initialize the memory switch setting that has been changed, follow the steps below.
1. Turn the printer power and open the printer cover.
2. Press and hold the POWER button and the FEED button simultaneously and allow the ERROR lamp to
ash ve times. Continuously hold the buttons until the buzzer sounds ve times. The POWER lamp
and the ERROR lamp ash and the memory switch is initialized to the factory setting.
3. Set a paper and close the printer cover. The printer prints out "Memory SW was initialized."
5 times
Continuously hold the buttons
until the buzzer sounds 5 times.
Memory switch is
initialized.
- 28 -
To Next Page
Loading...
