Star Micronics SP300 Series - 7 Control Codes; Control Codes Used for Character Setting; Control Codes Used for Line Spacing

– 29 –
7. CONTROL CODES
Control Codes Used for Character Setting
Control codes
Hexadecimal
Function Page
codes
<ESC> “R” n 1B 52 n Select international character set 32
<ESC> “6” 1B 36 Select IBM character set #2 32
<ESC> “7” 1B 37 Select IBM character set #1 32
<ESC> “M” 1B 4D Select 7 × 9 (half dot) font 33
<ESC> “P” 1B 50 Select 5 × 9 (2 pulses + 1 dot) font 33
<ESC> “:” 1B 3A Select 5 × 9 (3 pulses + 1 dot) font 33
<SO> 0E Select expanded character mode 33
<DC4> 14 Cancel expanded character mode 34
<ESC> “W” “1” 1B 57 31
Select expanded character mode 34
<ESC> “W” <1> 1B 57 31
<ESC> “W” “0” 1B 57 30
Cancel expanded character mode 34
<ESC> “W” <0> 1B 57 30
<ESC> “E” 1B 45 Select emphasized print mode 34
<ESC> “F” 1B 46 Cancel emphasized print mode 34
<ESC> “-” “1” 1B 2D 31
Select underline mode 35
<ESC> “-” <1> 1B 2D 01
<ESC> “-” “0” 1B 2D 30
Cancel underline mode 35
<ESC> “-” <0> 1B 2D 00
<ESC> “_” “1” 1B 5F 31
Select upperline mode 35
<ESC> “_” <1> 1B 5F 01
<ESC> “_” “0” 1B 5F 30
Cancel upperline mode 35
<ESC> “_” <0> 1B 5F 00
<ESC> “4” 1B 34 Select highlighted print mode 35
<ESC> “5” 1B 35 Cancel highlighted print mode 36
<SI> 0F Select inverted print mode 36
<DC2> 12 Cancel inverted print mode 36
Control Codes Used for Line Spacing
Control codes
Hexadecimal
Function Page
codes
<LF> 0A Line feed 36
<CR> 0D Line feed (same as LF) 36
<ESC> “z” “1” 1B 7A 31
Set 1/6-inch line feed 36
<ESC> “z” <1> 1B 7A 01
<ESC> “0” 1B 30 Set 1/8-inch line feed 37
<ESC> “a” n 1B 61 n Feed paper n lines 37