– 2 –
1-2. Switch Operation (Combined Switch Operation)
1 <SELF PRINT TEST>
FEED + POWER ON (Turn the power on while holding the FEED switch
depressed.)
Self-printing will be performed according to the VER. NO., DIP switch
settings and character order. When the FEED switch is held continuously
during self printing, only the characters will print out repeatedly.
In models with cutter, cutting will be done after self-printing is performed
according to the VER. NO., DIP switch setting and character order. When the
FEED switch is pressed after completed self-printing, character printing and
cutting will be repeatedly performed.
Fig. 1-2 Self printing sample (when using serial interface printer)
To Next Page
Loading...
