Star Micronics SP300 Series - Control Codes Used for Download Characters; Control Codes Used for Page Layout

– 30 –
Control Codes Used for Page Layout
Control codes
Hexadecimal
Function Page
codes
<FF> 0C Page feed (form feed) 37
<ESC> “C” n 1B 43 n Set page length at n lines 37
<ESC> “C” <0> n 1B 43 00 n Set page length at n inches 37
<ESC> “B” n1 n2 1B 42 n1 n2 Set vertical tab positions 38
<VT> 0B Execute vertical tab 38
<ESC> “N” n 1B 4E n Set bottom margin 38
<ESC> “O” 1B 4F Cancel bottom margin 39
<ESC> “1” n 1B 6C n Set left margin 39
<ESC> “Q” n 1B 51 n Set right margin 39
<ESC> “D” n1 n2 1B 44 n1 n2 Set horizontal tab position 40
<HT> 09 Execute the horizontal tab 40
Control Code Used for Graphics Printing
Control codes
Hexadecimal
Function Page
codes
<ESC> “1” 1B 31 Set 7/72-inch line feed 41
<ESC> “A” n 1B 41 n Define n/72-inch line feed 41
<ESC> “2” 1B 32 Set n/72-inch line feed 41
<ESC> “J” n 1B 4A n One time line feed of n/72-inch 41
<ESC> “z” “0” 1B 7A 30
Set 1/12-inch line feed 41
<ESC> “z” <0> 1B 7A 00
<ESC> “3” n 1B 33 n Set n/216-inch line feed simulation 42
<ESC> “y” n 1B 79 n Set n/144-inch line feed (Models with 1/44”
42
-pitch paper feed mechanism only)
<ESC> “K” n1 <0> 1B 4B n1 00 8 dot single density bit image 42
<ESC> “L” n1 n2 1B 4C n1 n2 8 dot double density bit image 44
<ESC> “h” “1” 1B 68 31
Select vertical expanded character mode 45
<ESC> “h” <1> 1B 68 01
<ESC> “h” “0” 1B 68 30
Cancel vertical expanded character mode 45
<ESC> “h” <0> 1B 68 00
Control Codes Used for Download Characters
Control codes
Hexadecimal
Function Page
codes
<ESC> “&” <0> n1 n2 1B 26 00 n1 n2 Definition of down load characters 46
<ESC> “%” “1” 1B 25 31
Enable download character set 47
<ESC> “%” <1> 1B 25 01
<ESC> “%” “0” 1B 25 30
Disable download character set 47
<ESC> “%” <0> 1B 25 00