– 32 –
7-1. Control Codes Used for Character Setting
FUNCTION
Select international character set
CODE
<ESC> “R” n
DEFINITION RANGE
(1B)H (52)H n
OUTLINE
(00)H n (08)H
Select the international character set corresponding to the
value set for n.
n =(00)
H: U.S.A. (03)H: England (06)H: Italy
(01)
H: France (04)H: Denmark (07)H: Spain
(02)
H: Germany (05)H: Sweden (08)H: Japan
The default international characters can also be set with DIP
switches, however, setting by control code takes priority over
setting by DIP switches.
Refer to chapter 11-5 “Code Table”
FUNCTION
Select IBM character set #2
CODE
<ESC> “6”
(1B)
H (36)H
OUTLINE
Selects IBM character set #2.
NOTE
This code is only valid when the character code table set by
DIP switches 2-1 and 2-2 is IBM character set #1 or #2.
FUNCTION
Select IBM character set #1
CODE
<ESC> “7”
(1B)
H (37)H
OUTLINE
Selects IBM character set #1.
NOTE
This code is only valid when the character code table set by
DIP switches 2-1 and 2-2 is IBM character set #1 or #2.
To Next Page
Loading...
