– 31 –
Control Codes Used for Peripheral Units
Control codes
Hexadecimal
Function Page
codes
<ESC> <BEL> n1 n2 1B 07 n1 n2 Adjust drive pulse width for peripheral unit 1 49
<BEL> 07 Deferred drive command for peripheral unit 1 49
<FS> 1C Immediate drive command for peripheral unit 1 49
<SUB> 1A Immediate drive command for peripheral unit 2 50
<EM> 19 Immediate drive command for peripheral unit 1 50
Other Control Codes
Control codes
Hexadecimal
Function Page
codes
<RS> 1E Sound buzzer 50
<CAN> 18 Cancel print data in buffer & Initialize printer 50
<DC3> 13 Set deselect mode 51
<DC1> 11 Set select mode 51
<ESC> “U” “1” 1B 55 31
Select uni-directional print mode 52
<ESC> “U” <1> 1B 55 01
<ESC> “U” “0” 1B 55 30
Select bi-directional print mode 52
<ESC> “U” <0> 1B 55 00
<ESC> “@” 1B 40 Initialize printer 52
<ENQ> 05 Enquiry 53
<STX> 02 Enter STX-ETX mode 53
<ETX> 03 Terminate STX-ETX mode 53
<ESC> “d” “0” 1B 64 30
<ESC> “d” <0> 1B 64 00 Trigger auto-cutter drive
54
<ESC> “d” “1” 1B 64 31 (Auto-cutting models only)
<ESC> “d” <1> 1B 64 01
<GS>...<LF> 1D...0A Selection of validation characters
54
(Models with validation function only)
To Next Page
Loading...
