– 13 –
LINE MODE
FUNCTION
Sets the magnification rate in character height.
CODE
<ESC> “h” n
HEX
1B 68 n
REMARKS
Prints the subsequent data magnified in character height by a rate
specified by the value of n.
n Character height n Character height
0 Unmagnify 3 Quadruple
1 Double 4 Quintuple
2 Triple 5 Sextuple
The value of n can be set to 0(00H) to 5(05H) or “0”(30H) to
“5”(35H).
FUNCTION
Sets the magnification rates in character width and height.
CODE
<ESC> “i” n1 n2
HEX
1B 69 n1 n2
REMARKS
Prints the subsequent data in the size specified by n1, n2.
n1 indicates the height magnification and n2 indicates the width
magnification.
n1 (n2) = 0 Normal height (or width) size.
1 Double height (or width) size.
2 Triple height (or width) size.
3 Quadruple height (or width) size.
4 Quintuple height (or width) size.
5 Sextuple height (or width) size.
The values of n1, n2 are 0(00H) to 5(05H) or “0”(30H)” to
“5”(35H).
FUNCTION
Underlining
CODE
<ESC> “–” n
HEX
1B 2D n
REMARKS
When the value of n is 1, underlines the subsequent data including
a character spacing set by <ESC><SP> n.
The part to be skipped by the horizontal tab setting and the block
graphic characters are not underlined.
Resets the underline mode when the value of n is 0.
The value of n can be set to 0(00H) or “0”(30H), or 1(01H) or
“1”(31H).
To Next Page
Loading...
