Star Micronics TSP600 Series - 4 DP8340 MODE (TSP800 Only); Command Summary

– 69 –
DP8340 MODE
4. DP8340 MODE (TSP800 ONLY)
4-1. Command Summary
Control codes
Hexadecimal
Function Page
codes
<LF> 0A Print and line feed instruction 70
<CR> 0D Print and line feed instruction 70
(Same as LF)
<SO> 0E Expanded character instruction 70
<DC4> 14 Expanded character release 70
<ESC> “
–
” “1” 1B 2D 31
Underline isrtruction
70
<ESC> “
–
” <1> 1B 2D 01
<ESC> “
–
” “0” 1B 2D 30
Underline release
70
<ESC> “
–
” <0> 1B 2D 00
<SI> 0F Inverted print instruction 71
<DC2> 12 Inverted print release 71
<ESC> “E” 1B 45 Emphasized print instruction 71
<ESC> “F” 1B 46 Emphasized print release 71
<ESC> “4” 1B 34 Highlighted character print instruction 71
<ESC> “5” 1B 35 Highlighted character print release 71
<ESC> “R” n 1B 52 n International Character set selection 72
<ESC> “a” n 1B 61 n n-line feed instruction 72
<ESC> “C” n 1B 43 n Sets page length in lines 72
<ESC> “N” n 1B 4E n Set bottom margin in lines 73
<ESC> “O” 1B 4F Cancel bottom margin 73
<FF> 0C Form feed 73
<ESC> “@” 1B 40 Printer initialization instruction 73
<ESC> <BEL> n1 n2 1B 07 n1 n2 Set peripheral unit drive pulse duration 73
<BEL> 07 Trigger peripheral unit drive #1 74
<FS> 1C Trigger peripheral unit drive #1 74
<SUB> 1A Trigger peripheral unit drive #2 74
<ENQ> 05 Enquiry 74
<CAN> 18 Clears print buffer 74