– 57 –
PAGE MODE
FUNCTION
Copy BMP file to printer
CODE
<ESC> “H n x1x2x3x4 , y1y2y3y4 ,
(BMP file data) ,” <LF> <NUL>
HEX
1B 48 n x1x2x3x4 2C y1y2y3y4 2C
(BMP file data) 2C 0A 00
REMARKS
This command copies BMP file to the printer(Image buffer). BMP
file can be scanned by scanner and edited by a program such as the
PAINT BRUSH in the WINDOWS. The printer can accept non-
compressed monochrome BMP file only.
BMP file contains white pixel (dots). There are two mode in this
command depending on how to handle these white pixels when
there are black pixels already set in the area to be printed on.
n : Mode “;” 3B(hex) “OR” mode : White pixels (area) of
BMP file do not erase black pixels previously set.
“:” 3A(hex) “OVERWRITE” : White pixels (area) of
BMP file erase(overwrite) black pixels previously set.
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
ABCDEFGHIJK
Data previously set Print out result
OR mode:
OVERWRITE mode:
BMP graphic file
x1x2x3x4 :Print start position in the X direction
y1y2y3y4 :Print start position in the Y direction
BMP file data :Command accepts BMP non-compressed mono-
chrome graphic file as binary file.
Note : Printer will result in an error on the following condi-
tions:
a) Error in command format structure
b) If either start position or image data is located out of
print area.
c) If a BMP file does not meet command specification.
(Printer can only accept non-compressed, mono-
chrome BMP file)
To Next Page
Loading...
