Star Micronics TSP700 Series - Set Page Length in Lines; Set Page Length in Inches; Set Bottom Margin

– 16 –
LINE MODE
Commands to Set the Page Format
FUNCTION
Set page length in lines
CODE
<ESC> “C” n
HEX
1B 43 n
REMARKS
Sets the page length using the current line spacing, where n is
between 1 and 127.
Changing the line spacing later does not alter the physical page
length.
The current line becomes the top of the page.
Resets the bottom margin.
Invalid when start position detect is ON.
FUNCTION
Set page length in inches
CODE
<ESC> “C” <0> n
HEX
1B 43 00 n
REMARKS
Sets the page length to n × 24 mm, where n is between 1 and 22.
Changing the line spacing later does not alter the physical page
length.
The current line becomes the top of the page.
Resets the bottom margin.
Invalid when start position detect is ON.
FUNCTION
Set bottom margin
CODE
<ESC> “N” n
HEX
1B 4E n
REMARKS
Sets the bottom margin to n lines at the current line spacing, where
n is between 0 and 255.
Changing the line spacing later does not alter the bottom margin.
Bottom margin is reset when you change the page length.
Setting is invalid if the printing area on one page is 36 mm or less.
Invalid when start position detect is ON.